Step 1
Allow a 2″ slot at the ridge of the metal roof for ventilation. Apply the LP2 Ridge Vent to metal roof by removing the backing paper.
Step 2
Align the LP2 Ridge Vent 1/2″-1″ up-slope from the edge of the ridge cap. Place onto metal roof with adhesive side down. Note that the adhesive is strong and, once put in place, it will be hard to move. Be sure the LP2 Ridge Vent is in place the first time.
Step 3
When attaching consecutive LP2 Vents, butt fit the pieces together. Marco’s Weather-Tite™ Metal Roof Sealant can be used to seal the butt joint. Place ridge cap over LP2. Secure in place with Marco QuickGrip™/QuickDrill™ fasteners; fasten through the metal roof ridge locations utilizing the screw bed locations to avoid penetrating the LP2 insert material utilizing the screw bed locations.